CLAAS LEXION 500 series (520, 570) — 28c - AUTOPILOT – GPS-controlled steering

Key to diagram: Coordinates A9 AUTOPILOT module ........................................................... 2-i-20 B5 Working hydraulics / Autopilot oil pressure sensor ............ 4-n-19 (for pressure-controlled equipment) B6 AUTOPILOT wheel angle sensor........................................6-r-18 B83 AUTOPILOT OFF sensor (overrider switch) ...................... 5-g-18 DO Master valve diode PCB...................................................... 4-i-20 DS Diagnosis plug (63-pin) VIA................................................. 3-i-20 H2 AUTOPILOT signal light.....................................................

4-g-18 K14 Threshing mechanism relay ................................................ 4-i-20 K52 Power supply relay .............................................................. 4-i-20 R3 AUTOPILOT centralizing switch (set value)....................... 3-h-17 S9 AUTOPILOT ON switch...................................................... 4-g-17 S10 AUTOPILOT main switch ................................................... 3-h-17 S96 AUTOPILOT laser right/left switch ..................................... 3-h-17 W2 GPS antenna....................................................................... 2-f-18 X4 Steering column indicator lights connector ........................

4-g-18 XV3 AUTOPILOT variant plug connector ................................... 8-f-20 Y9 AUTOPILOT left solenoid coil ............................................ 4-n-19 Y10 AUTOPILOT right solenoid coil .......................................... 4-n-19 Z5 Seat contact actual value switch ........................................

4-h-18 a- provided depending on equipment fitted Power supply Signal / linear, Master valve (Y77) circuit via module (A9) - On at 135 bar - Off at 165 bar B6 AUTOPILOT wheel angle 12 V 0.25 V - 4.75 V Power supply Signal R3 Potentiometer 4.70 k Ω 1.7 - 6.4 k Ω (Pin A-E) coil (Pin S-E) slider Y 9 Y10 Solenoid coil 3.8 A 3.2 Ω See inscription, without diode Measured value table:

Item Component Measured value Remark B5 Working hydraulics / Autopilot oil pressure 12 V 0.25 V - 4.75 V 0.25 V = 0 bar 4.75 V = 250 bar Electric System LEXION 500 TIC 28c-2 Lex-e-28c 28c AUTOPILOT – GPS-controlled steering Item Component Measured value Remark B5 Working hydraulics / Autopilot oil pressure 12 V 0.25 V - 4.75 V 0.25 V = 0 bar 4.75 V = 250 bar Power supply Signal / linear, Master valve (Y77) circuit via module (A9) - On at 135 bar - Off at 165 bar B6 AUTOPILOT wheel angle 12 V 0.25 V - 4.75 V Power supply Signal R3 Potentiometer 4.70 kΩ 1.7 - 6.4 kΩ (Pin A-E) coil (Pin S-E) slider Y 9 Y10 Solenoid coil 3.8 A 3.2 Ω See inscription, without diode