CLAAS LEXION 500 series (520, 570) — 41t - Axle control system and front attachment contr

Electric System LEXION Montana 570-520 TIC Measured value table: Description of function: Axle control system The system identifies the machine position using the inclination sensors B126-1 / B126-2 which transmit their values to the MONTANA GEN II module (A42) via an internal CAN bus. The solenoid coils (Y114, Y115, Y116, Y117) are actuated by the MONTANA GEN II module (A42) so that the machine is always in a vertical position by means of front axle movements. Front attachment control system The position of the front attachment is adapted by rotating the front attachment frame (Y112, Y113) and by changing the cutting angle (Y110, Y111).

This front attachment control system works in addition to and independently of the CLAAS AUTO-CONTOUR system (CAC). The MONTANA GEN II module (A42) receives the necessary feedback about the current position of the corresponding function from the respective angle sensors (B91, B92, B93, B94, B95). Montana axle hydraulics master valve The MONTANA GEN II module energizes the working hydraulics master valve (Y77) with priority, according to the actuated MONTANA functions. Actuation here is via the CAN bus. Only when the control deviation becomes too small within a defined period of time (e.g.

machine raises too slowly), the MONTANA master valve (Y128) is additionally energized – see circuit diagram 4t. Calibration of MONTANA system All calibrations are carried out via the CEBIS terminal in connection with the CLAAS Diagnosis System CDS. Diagnosis of MONTANA system Reading out of data and display of sensor values is by means of the CLAAS Diagnosis System CDS. 41t-4 Lex-e-41t 03/05 Item Component Measured value Remark B91 B92 B93 B94 Sensor 12 V 0.25 V - 4.75 V (Pin 1-2) (Pin 1-3) Y110 Y111 Y112 Y113 Solenoid coil 3.8 A 3.2 Ω See lettering Y114 Y115 Y116 Y117 Solenoid coil 3.8 A 3.2 Ω PWM, see lettering