CLAAS LEXION 500 series (520, 570) — Module A66 - GPS pilot module (GPB)

TIC LEXION Montana 570-520 Elecric System Description of function: Starting The engine controller module (A15) is activated via relay K51 by the ignition lock (S64). During the starting procedure, the engine controller module (A15) receives the speed signal from the sensor provided on the camshaft and starts the injection. Engine monitoring All sensors relevant for operation and monitoring of the engine are mounted on the engine wiring loom. Only the water level sensor is connected to the CLAAS wiring loom. The engine controller module (A15) transmits the signals for displaying the engine speed, the coolant level and the coolant temperature to the CAB module (A10) via the CAN bus J1939.

The CAN module (A10) converts this signal to the CLAAS CAN bus, thus allowing display on the terminal. Engine diagnosis The number of engine errors occurred and the corresponding error codes can be displayed in the terminal. Further diagnosis is carried out via the diagnosis plug in the central terminal compartment, using the Caterpillar diagnosis tool CAT-ET. The display of error codes can also be activated by the diagnosis LED (D2) after actuating the rocker switch (U22). Diesel engine speed adjustment The diesel engine speed depends on the position of switch S35 and of the 2nd gear actual value switch (Z83) – see also circuit diagram 42s.

If full throttle speed is selected and the 2nd gear engaged (signal input A36 / pin 4), the connection between A10/18 and A10/19 inside the Montana gearshift control module (A36) is cut (pins 10 and 11) – see also circuit diagram 42s. The full throttle speed is reduced to road travel speed, depending on the country version. The maximum speed which can be achieved now can be configured using the Claas diagnosis system CDS. 03/05 Lex-e-02s 2s-3 LEXION Type Idle speed (S35) Full throttle at no load (S35) 20 km/h (Z83) 25 km/h (Z83) Montana 570-520 1200 rpm 2100 rpm 1568 rpm 1960 rpm