CLAAS LEXION 500 series (520, 570) — Module A66 - GPS pilot module (GPB)

TIC LEXION 500 Electric System Description of function: Time relay K58 The electronic circuit in time relay K58 delays the release circuit to the individual consumers by approx. 1.5 sec. and therefore guarantees stable operating voltage for the starting procedure. Charging voltage warning Insufficient or absent charging voltage is indicated by alternator charging light (H19). At the same time, the analogue voltage signal of the alternator (G2) is monitored by the fieldwork computer module (A10) and displayed as an alarm in terminal (A30) if necessary. Total failure of the alternator (G2) is reported as a defective V-belt of the cooling water pump in terminal (A30) (see also diagram 1).

Coolant level warning The explanations regarding the coolant level warning can be found in diagram 2a of the CAT diesel engine and diagram 2b of the DC diesel engine. Air filter maintenance warning The earth signal of the vacuum switch (Z69) is switched to terminal (A30) and in parallel via the diode PCB (DI) to the transducer K57. Temperature warning For a coolant excess temperature warning, the engine controller module (A15) transmits the corresponding signal to the CAB module (A10) via the CAN bus J1939. The CAB module (A10) converts this signal to the CLAAS CAN bus, allowing display on the terminal.

At the same time and as a protective function, the diesel engine reduces its maximum power. Temperature display For coolant temperature display, the engine controller module (A15) transmits the corresponding signal to the CAB module (A10) via the CAN bus J1939. The CAB module (A10) converts this signal to the CLAAS CAN bus, thus allowing display on the terminal. Error code Active error codes according to ISO J1939 are displayed in terminal A30 in menu item "Engine loading". 03/05 Lex-e-03a 3a-3