Automatic Lubrication System - Section 42 OM4210 Page 42-6 LUBRICANT PUMP Pump Housing Oil Level The pump housing must be filled to the proper level with SAE 10W-30 motor oil. Oil level should be checked at 1000 hour intervals. To add oil, remove pipe plug (4, Figure 42-5) and fill housing to bottom of plug hole. Pump Pressure Control High pressure hydraulic fluid from the truck steering system is reduced to 2240 - 2413 kPa (325 - 350 psi) by the pressure reducing valve located on the manifold on top of the pump motor. This pressure can be read if pipe plug (3) is removed, and a gauge is installed on the manifold.
Pressure should be checked occasionally to verify the pressure is within the above limits. Pressure Control Valve Adjustment FIGURE 42-5. PUMP CONTROLS The pressure control valve (1) has been factory adjusted and the setting should not be disturbed. 1. Pressure Control Valve 2. Override Switch 3. Pipe Plug 4. Oil Level Plug 5. Flow Control Valve Flow Control Valve Adjustment The flow control valve (5) is factory adjusted to 9.5 lpm (2.5 gpm). Do not change this setting.