OM2044 Safety - Section 20 Page 20-5 Mirrors, Windows, And Lights Remove any dirt from the surface of the windshield, cab windows, mirrors and lights. Good visibility may prevent an accident. OPERATING THE MACHINE Starting The Engine Adjust the mirrors to a position where the operator can see best from the operator's seat. NEVER ATTEMPT TO START THE MACHINE BY SHORTING ACROSS THE STARTER TERMINALS. This may cause fire, or serious injury or death to anyone in machine’s path. Ensure headlights, work lights and taillights are in proper working order. Ensure that the machine is equipped with the proper work lamps needed for the operating conditions.
NEVER start the engine if a warning tag has been attached to the controls. When starting the engine, sound the horn as an alert. Replace any broken mirrors, windows or lights. Start and operate the machine only while seated in the operator’s seat. In The Operator’s Cab - Before Starting The Engine DO NOT allow any unauthorized persons in the operator's compartment or any other place on the machine. DO NOT leave tools or spare parts lying around or allow trash to accumulate in the cab of the truck. Keep all unauthorized reading material out of the truck cab. Truck Operation - General Keep the cab floor, controls, steps, and handrails free of oil, grease, snow, and excess dirt.
WEAR SEAT BELTS AT ALL TIMES. Only authorized persons are allowed to ride in the truck. Passengers must be in the cab and belted in the passenger seat. Check the seat belt, buckle and hardware for damage or wear. Replace any worn or damaged parts. Always use the seat belts when operating a machine. DO NOT allow anyone to ride on the decks or on the steps of the truck. Read and understand the contents of the Operation & Maintenance manual. Read safety and operating instructions with special attention. Become thoroughly acquainted with all gauges, instruments and controls before attempting operation of the truck. DO NOT allow anyone to get on or off the truck while it is in motion.
DO NOT move the truck in or out of a building without a signal person present. Know and obey hand signal communications between the operator and spotter. When other machines and personnel are present, the operator must move in and out of buildings, loading areas and through traffic, under the direction of a signal person. Courtesy at all times is a safety precaution! Read and understand the WARNING and CAUTION decals in the operator's cab. Ensure the steering wheel, horn, controls and pedals are free of any oil, grease or mud. Check operation of the windshield wiper, condition of wiper blades, and check the washer fluid reservoir level.
Immediately report any adverse conditions on haul road, pit or dump area that may cause an operating hazard. Be familiar with all steering and brake system controls, warning devices, road speeds and loading capabilities, before operating the truck.