Komatsu — WARNINGS AND CAUTIONS

Warnings And Cautions - Section 22 OM2222 Page 22-2 Attached to the exterior of both battery compartments is a danger plate. This plate stresses the need to keep from making any sparks near the battery. When another battery or 24VDC power source is used for auxiliary power, all switches must be OFF prior to making any connections. When connecting auxiliary power cables, positively maintain correct polarity. Connect the positive (+) posts together and then con- nect the negative (-) lead of the auxiliary power cable to a good frame ground. DO NOT connect to the negative posts of the truck battery or a ground near the battery box.

This hookup completes the circuit but minimizes danger of sparks near the bat- teries. Sulfuric acid is corrosive and toxic. Use proper safety gear, goggles, rubber gloves and rubber apron when handling and servicing batteries. Get proper medical help immediately, if required. This plate is placed on isolation box cover and the battery box cover to indicate that the battery system (24VDC) is a negative (-) ground system. This decal is located on the battery box cover. It details the correct procedure for disconnecting the battery cables from the batteries. Before disconnect- ing the battery cables, turn the key switch to the OFF position and wait for the engine to stop.

After the engine has stopped, wait two minutes, and if no warning lights illuminate, then turn the battery discon- nect switches to the OFF position.