OM3058 Operating Instructions - Section 30 Page 30-1 TRUCK OPERATION PREPARING FOR OPERATION Local work practices may prevent an operator from performing all tasks suggested here. To the extent permitted, the operator must follow this or a similar routine. The safest trucks are those which have been prop- erly prepared for operation. At the beginning of each shift, a careful check of the truck must be made by the operator before starting the engine. Safety Is Thinking Ahead Prevention is the best safety program. Prevent a potential accident by knowing the employer's safety requirements, all necessary job site regulations, as well as use and care of the safety equipment on the truck.
Only qualified operators or technicians can operate or maintain a Komatsu truck. High voltage may be present on this truck! DO NOT open any electrical cabinet doors on the truck while the engine is operating! Never climb on any power cables or use power cables for handholds or footholds, unless the engine has been shut off and the system has been verified as at rest! Safe practices start before the operator gets to the equipment! Wear the proper clothing. Loose fitting clothing, unbuttoned sleeves and jackets, jewelry, etc., can catch on a protrusion and cause a potential hazard. 1. Start at left front of the truck.
While performing the walk around inspection, visually inspect all lights and safety equipment for external dam- age from rocks or misuse. Ensure lenses are clean and unbroken. Always use the personal safety equipment provided for the operator such as hard hats, safety shoes, safety glasses or goggles. There are some conditions when protective hearing devices must also be worn for operator safety. Empty the dust pans on the left side of the air cleaners. Ensure the battery box covers are in place and secure. When walking to and from the truck, maintain a safe distance from all machines, even if the operator is visible. 2. Move behind the front of the left front tire.
Inspect the hub and brake assemblies for leaks and any abnormal conditions. 3. Check that all suspension attaching hardware is secure and inspect the mounting key area for evidence of wear. Check that the suspension rod extension is correct, and that there are no leaks. Ensure the suspension protective boot is in good condition. WALK AROUND INSPECTION At the beginning of each shift, a careful walk around inspection of the truck must be performed before the operator attempts engine start-up. A walk around inspection is a systematic ground level inspection of the truck and its components to ensure that the truck is safe to operate before entering the operator's cab. 4.
Inspect the anchor end of the steering cylinder for proper greasing and all parts are secure. 5. With the engine stopped, check the engine oil level. Use the service light if necessary. Start at the left front corner of the truck (see illustra- tion, next page), and move in a counter-clockwise direction. Move front-to-rear, across the rear, and continuing forward up the opposite side of the truck to the original starting point. 6. Inspect air conditioner belts for correct tension, obvious wear, and tracking. Inspect fan guard security and condition. When leaving this point, be sure to turn off the service light, if used. 7. Move outboard of the front wheel.
Inspect attaching lugs/wedges to be sure all are tight and complete. Inspect the tires for cuts, dam- age or bubbles. Check tire inflation pressure. Check sight glass for front wheel oil level. If these steps are performed in sequence, and are repeated from the same point and in the same direc- tion before every shift, many potential problems may be avoided, or scheduled for maintenance. Unsched- uled downtime and loss of production can be reduced as a result.