Operating Instructions - Section 30 OM3058 Page 30-12 Lowering The Dump Body (When dumping over a berm or into a crusher): SUDDEN LOSS OF ENGINE POWER If the engine suddenly stops, there is enough hydrau- lic pressure stored in the brake and steering accumu- lators to allow the operation of the steering and brake functions. However, this oil supply is limited so it is important to stop the truck as quickly and safely as possible after the loss of engine power. 1. Move the hoist lever to the DOWN position and release. Releasing the lever places the hoist control valve in the FLOAT position allowing the body to return to the frame. NOTE:
If dumped material builds up at the rear of the body and the body cannot be lowered, perform Steps a & b below: If the brake supply pressure drops to a pre-deter- mined level, the low brake pressure warning light will illuminate and a buzzer will sound. If the brake pres- sure continues to decrease, the auto-apply feature will activate and the service brakes will apply auto- matically to stop the truck. a. Move the hoist lever back to the HOIST position to fully raise the dump body. Release the hoist lever to return it to the HOLD position. 1. Bring the truck to a safe stop as quickly as pos- sible by using the foot pedal to apply the ser- vice brakes.
If possible, safely steer the truck to the side of the road while braking. NOTE: DO NOT drive forward if the tail of the body will not clear the crusher wall in the fully raised position. b. Move the directional control lever to FOR- WARD, release the brake lock. Depress the override button and drive forward to clear the material. Stop, shift the directional control lever to NEUTRAL, apply the brake lock and lower the body again. Dynamic retarding will not be available! DO NOT use the service brakes for continuous retarding purposes. 2. As soon as the truck has stopped moving, shift the directional control lever to PARK. This will apply the parking brake. NOTE:
When an attempt to lower the body is unsuccessful because of material obstruction, raise the body back up. This will help to prevent the body from suddenly dropping when pulling away from the obstruction. 3. Slowly release the service brakes to check the capacity of the parking brake. If the parking brake can not hold the truck stationary, apply the service brakes and hold them ON. DO NOT turn the key switch OFF, and DO NOT release the service brakes. 4. Notify maintenance personnel immediately. CAUTION! DO NOT move the truck with the dump body raised except for emergency purposes only.
Failure to lower the body before moving the truck may cause damage to the hoist cylinders, frame and/or body hinge pins. 5. If the truck is on level ground, or if the parking brake can hold the truck stationary and the truck is in a stable condition, it is then OK to turn the key switch OFF. 6. If safe to do so, have maintenance personnel place wheel chocks or other mechanisms in front or behind the wheels to reduce the risk of the truck rolling. 2. With the body returned to the frame, move the directional control lever to FORWARD, release the brake lock, and carefully leave the dump area. 7.
If traffic is heavy near the disabled machine, mark the truck with warning flags during day- light hours or use flares at night. Adhere to local regulations.