Operator Cab And Controls - Section 32 OM3242 Page 32-22 C1. Low Accumulator Pre- charge Pressure A2. Low Hydraulic Tank Level This warning light indicates the oil level in the hydraulic tank is below recommended level. Dam- age to hydraulic pumps may occur if operation continues. Stop the truck and turn the engine off. Notify maintenance personnel immedi- ately. The low accumulator precharge warning light, if illuminated, indi- cates low nitrogen precharge for the steering accumulator(s). To check for proper accumulator nitrogen precharge, the engine must be stopped and the hydraulic system completely bled down. Turn the key switch to the RUN position.
The warning light will not illuminate if the accumulators are properly charged. The warning light will flash if the nitrogen precharge within the accumulator(s) is below 7585 ± 310 kPa (1100 ± 45 psi). B2. Automatic Lubrication Sys- tem Pressure This amber light will illuminate if the automatic lubrication system fails to reach 13 790 kPa (2,000 psi) at the junction block located on the rear axle housing within a specified time after the lube timer initiates a cycle of grease. To turn the light off, turn key switch OFF, then back to ON again. Notify maintenance personnel at earliest opportunity after light comes on.
If the low accumulator precharge warning light flashes, notify maintenance personnel immedi- ately. Do not attempt further operation until the accumulators have been recharged with nitro- gen. Refer to the shop manual for proper charg- ing instructions. If nitrogen precharge pressure is low, sufficient oil for emergency steering may not be available. D1. Not Used C2. Circuit Breaker Tripped This light is reserved for future use. This amber light will illuminate if any of the circuit breakers in the relay circuit control boards are tripped. The relay circuit boards are located in the electrical con- trol cabinet. E1.
Low Brake Pressure This red indicator light indicates a malfunction within the hydraulic brake circuit. If this light illumi- nates and the buzzer sounds, stop the truck, shift to PARK, and turn the engine off. Notify maintenance personnel. D2. Hydraulic Oil Filter Monitor This amber light indicates a restriction in the high pressure fil- ter assembly for either the steer- ing or hoist circuit. This light will illuminate before filters start to bypass. Notify maintenance per- sonnel at earliest opportunity after the light illumi- nates. NOTE: Adequate hydraulic fluid is stored to allow the operator to safely stop the truck. NOTE:
The filter monitor warning light may also illuminate after the engine is initially started if the oil is cold. If the light turns off after the oil is warmed, filter maintenance is not required.