TRENCHING ATTACHMENT 1820 - MAINTENANCE 73 TRENCHING ATTACHMENT p 1820 - MAINTENANCE 73 TRENCHING ATTACHMENT TRENCHING ATTACHMENT Chain Wear Chain Wear Replace worn or broken chains. If sidebars are bending or getting loose on chain pins, chain spacers should be used to join sidebars. Replace worn or broken chains. If sidebars are bending or getting loose on chain pins, chain spacers should be used to join sidebars. Digging Chain Digging Chain Visually check digging chains for wear on rollers and sidebars. Check pins and bushing wear by measuring distance between chain pins and comparing it to new chain. Visually check digging chains for wear on rollers and sidebars.
Check pins and bushing wear by measuring distance between chain pins and comparing it to new chain. Replace sprockets when new chain is installed. Replace sprockets when new chain is installed. To remove digging chain: To remove digging chain: 1. Start unit, following directions in OPERATION section. 1. Start unit, following directions in OPERATION section. 2. Turn digging chain until connector pin is on top of boom. 2. Turn digging chain until connector pin is on top of boom. 3. Lower boom to ground. 3. Lower boom to ground. 4. Stop engine. 4. Stop engine. 5. Secure chain. 5. Secure chain. Sprocket booms - Lock rear idler sprocket. Sprocket booms - Lock rear idler sprocket.
Roller booms - Clamp links on either side of connector pin with chain jaws. Squeeze jaws to reduce pressure on connector pin. Roller booms - Clamp links on either side of connector pin with chain jaws. Squeeze jaws to reduce pressure on connector pin. om1752 om1752