PACCAR Corporation — Cab Electronic Control Unit (CECU)

Multiplexed Electrical System Service Manual 8 CAUTION Chassis Node Any attempt to cut or attach directly to the CAN wire except through a provided connector, may cause equipment malfunction, equipment damage and will void the manufacturer’s warranty. The node that receives information from the CECU to control, exterior lighting, Electric over Air controls, and windshield wipers is called the chassis node. The chassis node serves as a bidirectional conduit for both information and control. These inputs are hardwired to the chassis node and broadcast to the CECU.

Ammeter Auxiliary Transmission Oil Temperature Axle Temperature, Rear Axle Temperature, Front Axle Temperature, Center / Steer Back Up Switch Differential Lock Telltale Fuel Filter Restriction General Oil Temperature PTO Oil Temperature Transfer Case Oil Temperature The inputs from these sensors are fed into the chassis node where the information is then processed into data and sent to the CECU by way of the CAN (Controller Area Network) data bus, specifically the F-CAN. In addition to receiving and processing sensor data, the chassis node also controls the operation of relays that power several electrical subsystems. These include:

Back Up Alarm Windshield Washer The information sent from the sensors attached to the chassis node is sent to the CECU, processed, and where appropriate returned to the chassis in the form of commands related to the outputs controlled by the chassis node. The design and manufacture of the chassis node is such that it is delivered to the plant or dealership without configuration parameters loaded into it. Upon the first power cycle of the system the CECU downloads the appropriate configuration parameters so that the chassis node can setup its I/O correctly.

Depending on the software configuration of the CECU, these parameters may be different than other trucks and unique PM819023/KM815057 (08/14/2012) 8 - 3