24. SERVICE PROCEDURE 4. If the strainer is damaged, replace it with a new one. 5. Remove all dirt from the strainer, then wash in clean diesel oil or flushing oil. Clean the inside of the case and the plugs at the same time. 6. Install the strainer to its original position. 7. Replace the transmission oil filter. For details, see “24.6 EVERY 500 HOURS SERVICE”. 8. Add engine oil through oil filler port @ to the specified level. For details of the oil to use, see “20. USE OF FUEL AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 9. After adding the oil, check the oil level. For details, see “24.3 CHECK BEFORE STARTING”. 24.7.3 REPLACE HYDRAULIC OIL FILTER ELEMENT has operated.
Wait for the oil to cool down before changing the When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it carefully. I I \ Lower the blade to the ground and stop the engine. Move the blade control lever to the front and rear (left and right), then turn the cap of oil filler port @ slowly to release the pressure before removing the cap. Loosen bolt 0, remove cover 0, then take out the element. Clean the inside of the case and the removed parts, then install a new element. Always use a Komatsu genuine element. 3-56