24. SERVICE PROCEDURE 24.8.3 CHANGE OIL IN HYDRAULIC TANK The oil is at high temperature immediately after the machine FP__I_] has been operated. Wait for the oil to cool down before chang- When removing the oil filler cap, turn it slowly to release the internal pressure, then remove the cap carefully. l Refill capacity: 65 e (17.17 US gal, 14.30 UK gal) l Oil container: Min. 65 e (17.17 US gal, 14.30 UK gal) l Prepare a socket wrench and filter wrench. 1. Lower the blade to the ground and stop the engine. Move the blade control lever to the front and rear (left and right), then turn the cap of oil filler port @ slowly to release the internal pressure, and remove the cap. 2.
Place a container to catch the oil under drain plug @ at the bottom of the tank. 3. Remove drain plug @ and drain the oil. After draining the oil, tighten drain plug @. When removing drain plug @, be careful not to get oil on yourself. 4. Add engine oil through oil filler @ to the specified level. For details of the oil to use, see “20. USE OF FUEL, COOLANT, AND LUBRICANT ACCORDING TO AMBIENT TEMPERATURE”. 5. After adding oil, check that the oil is at the specified level. For details, see “24.5 EVERY 250 HOURS SERVICE”. 3-60