SWITCHES 35. Lights, Hazard With the switch in the ON position, the emergency flasher makes all four turn signals (front and rear) flash simultaneously. The flasher works independently of the ignition switch. You should always use the flasher if the vehicle is disabled or parked under emergency conditions. 38. Lights, Marker/Clearance/Cab Turn switch on to control Cab Marker/Clearance lights separately from the trailer. If you have confirmed there is a problem in the low beam wiring circuit, proceed with caution to the next available exit/turnoff and safely pull your vehicle completely off the road and call for assistance.
Driving your vehicle with the headlamps on high beam (at reduced intensity) for a prolonged period could lead to an injury accident. Contact your nearest dealer to have the problem corrected as soon as possible. CAUTION 39. Lights, Marker/Clearance/Trailer Turn switch on to control Trailer Marker/Clearance lights separately from the vehicle marker/clearance lights. 3 WARNING Use your Hazard Warning Light System any time you have to stop off the road or on the side of the road, day or night. A hard-to-see vehicle can result in an injury accident. Another vehicle could run into you if you do not set your flashers and follow the placement of emergency signals per FMCSR 392.22. 40.
Lights, Park Light Turn switch on for Park Lights. When the Park Lights are on the dash lights, side and tail lights are also on. 41. Lights, Spot Turn switch on for Spot Light. 37. Lights, Marker/Clearance Turn switch on to control Cab and Vehicle Marker/Clearance lights. 42. Mud & Snow Traction Control Momentarily push switch in to engage Traction Control (TC). NOTE 36. Lights, Headlight Turn switch on for headlights. When the Headlights are ON, the dash lights, side, and tail lights are also on. An interrupt switch for the trailer marker lights is mounted on the end of the turn signal lever. 43. Pintle Hook Turn switch on to remove the slack from the Tow Hook. 3-64