PACCAR Inc. — Putting the Vehicle in Motion

OPERATING THE TRANSMISSION obtained. For further information, see More Driving Tips and Techniques on page 4-56 . Shifting Gears in a New Vehicle Clutch Brake and Travel The clutch brake is used for stopping transmission gears, allowing you to easily shift into first gear or reverse without grinding gears. Approximately the last Ѕ inch (13 mm) of clutch pedal travel activates the clutch brake. Shift carefully in a new vehicle. The transmission may be a little stiff at first. Avoid gear clashing, by closely following these procedures.

When you are operating a new vehicle or one that has been exposed to cold weather, you want the transmission lubricant (fluid) to circulate and coat the contacting surfaces of the gears. Metal contacting metal in moving parts may seriously damage your transmission, do not drive in one gear for long periods of time until the transmission lubricant has a chance to coat all contacting surfaces. To apply the clutch brake (while the vehicle is stopped) fully depress the clutch pedal to stop the gears. With the throttle at idle, select first gear then release the clutch pedal to let the vehicle start forward, until the clutch is fully engaged.

See the manufacturer's Driver/Operator's Instruction Manual for further details. 4 If the transmission has a butt-tooth condition and you cannot engage a gear, gradually release the clutch. Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift. 4-16