PACCAR Inc. — Cruise Control Switch

CRUISE CONTROL CRUISE CONTROL Setting Cruise Speed Cruise Control Switch 1. Ensure that the vehicle speed is above the minimum cruise control speed (19 mph (30 km/h) for PACCAR MX engine and 30 mph (48 km/h) for the Cummins engines) and the engine speed is above 1100 rpm. Changing the Cruise Set Speed This vehicle may have cruise control switches located on the steering wheel instead of the switches on the dash board. The instructions are still the same. Please see Steering Wheel Controls on page 3-72 to determine where the cruise control switches are located. For vehicles with cruise control buttons on the steering wheel, the cruise speed may be changed by using the +/- button.

The pressing and holding the + button will increase speed while pressing and holding the - button will decrease speed. For vehicles with dash mounted cruise control switches, changing the speed is done through the "Set/Resume" button. To increase the speed, press and hold the Set button. To decrease the speed, press and hold the "Resume" button. 2. Press the "ON/OFF" button. 3. Accelerate the vehicle to the desired cruise speed. 4 For information about the Adaptive Cruise Control, see Adaptive Cruise Control on page 4-38 . 4. Press the "SET" button to set the cruise speed. To Turn On: Cruise Control may not hold the set speed going down hills.

If the speed increases going down a hill, use the brakes to slow down. This will cancel Cruise Control. NOTE Cancelling Cruise Control Press the ON/OFF button. You can cancel cruise control in any of these ways: To Turn Off: Tap the brake pedal. Press the ON/OFF button. Any previous speed settings are cleared. Tap the clutch pedal. Using Cruise Control While Driving 4-36