PACCAR Inc. — Auxiliary Axles - Pusher or Tag

AXLE General Calibration Guidelines some non-liftable axles, inflate air suspension). Operation guidelines 4. Adjust the amount of load on each axle by turning the pressure regulator clockwise to increase the load or counterclockwise to decrease the load. (The suspension manufacturer may publish pre-established Pressure-to-Load Ratio Pressure Settings to assist you in achieving an estimated ground load). NOTE These instructions are general in nature. For more specific instructions, review the pusher or tag suspension manufacturers maintenance manual or contact the nearest authorized dealer.

Steerable-pusher and/or tag axle(s) will raise when the transmission is shifted into reverse or when the parking brakes are applied. NOTE Perform this procedure at or near a weight scale. Procedure can be performed while parked on the weight scale if scale is available. 4 5. After setting the pressure to obtain the desired axle load, verify proper ground loading with the weight scale. 1. Park loaded vehicle on level surface with wheels blocked. 2. Release vehicles spring brakes. (Do not release for Liftable/Non-Steerable pusher or tag axles). NOTE Exceeding local, state or federal weight limits may result in citations.

Contact your local commercial weight enforcement office for limits in your area. 3. Lower the pusher/tag axles with the axle lift control flip valve. (For 4-48