SUSPENSION Completing this procedure will enable you to safely reach the nearest authorized Peterbilt repair facility to have ride height and pinion angle reset using the proper equipment and technique. Do this as soon as possible to avoid potential driveline damage. CAUTION At least one of the mounting holes in the height control valve bracket will be slotted to permit rotating the valve. NOTE On dual-valve systems, begin with the LH valve on the next step. Typical Height Control Valve (Location on Vehicle) 3. Loosen the fasteners mounting a height control valve to its bracket. 4 NOTE Suitable wheel chocks are at a minimum an 18-inch (46 cm) long 4x4. 1.
Ensure that the tractor is fully laden during this procedure. Do not use these procedures on a vehicle that is not laden (bobtail). Typical Height Control Valve (Rear View Looking Forward) 2. Ensure the air supply and delivery plumbing of the height control valve is consistent with the following illustrations. 1. Alignment Dowel 4-52