PACCAR Inc. — Maintenance Schedule

PREVENTIVE MAINTENANCE SCHEDULE 5 5-17 PREVENTIVE MAINTENANCE (PM) INTERVALS SYSTEM COMPONENT MAINTENANCE TASK Recommended PM Interval I A B C D E Drive Axle (Meritor) Axle Housing Check the “cold” fill level at the differential carrier plug for a pinion angle of less than 7 degrees, or at the axle bowl plug for a pinion angle of greater than 7 degrees. Tighten the plug to 35-50 Lb. ft. (47-68 N.m.) X Visually inspect for damage or leaks. X Drain and replace the lubricant. See information on page 5-42 Lubricant filter Change the filter. X Breather Check the operation. If the cap doesn’t rotate freely, replace. X Input shaft & pinion shaft Check and adjust the endplay.

X Axle shaft Tighten the rear axle flange nuts to the specified torque value. X Interaxle differential Check the operation. X Drive Axle (SISU) Axle Housing Change the oil in the differential carrier and the hubs, and clean the magnetic oil drain plugs. X X Check the wheel bearing hubs and adjust if necessary. X X Visually inspect for damage or leaks. X X Check the oil level in the differential carrier and hubs. X Breather Check the breather for proper operation. X Lube Filter Clean the suction filter for the optional pressure lubrication system. X S-cam brakes Overhaul the brakes; degrease all moving parts; check the bushings and seals for wear. X