LUBRICANT SPECIFICATIONS Change the lubricant filter every 120,000 miles (192,000 km). Top off the lubricant level with a similar lubricant. Eaton/Dana Axle Lubrication Change the lubricant within the first 5000 miles (8000 km) of operation after a carrier head replacement, regardless of the lubricant type. The original mineral-based lubricant must be drained within 3000-5000 miles (4800-8000 km) on all Eaton axles. This initial change is very important because it flushes out break-in contaminants that might otherwise cause premature wear. Refer to the Eaton Field Maintenance Manual for a particular axle for lubricant specifications.
5 No initial drain is required on Eaton axles that are factory filled with an Eaton-approved synthetic lubricant. See your dealer for Eaton-approved lubricant brands. Refer to the chart below for lubricant change interval. Mineral-based lubes must be drained within the first 5000 miles (8000 km) if converting to an Eaton-approved synthetic lube. 5-44 Application Type Of Lubricant Mileage Interval City Delivery Synthetic 120,000 mi. (192,000 km) Synthetic with Pump and Filter 240,000 mi. (384,000 km) Mineral Base 120,000 mi. (192,000 km) Off Highway Synthetic 120,000 mi. (192,000 km) Synthetic with Pump and Filter 120,000 mi. (192,000 km) Mineral Base 120,000 mi. (192,000 km)