NOISE AND EMISSION CONTROL Inspection and Maintenance Instructions Air Intake System Engine Mounted Noise Insulators Do all checks and maintenance procedures listed in this manual under Engine Air Intake System and Air Cleaner. See Air Dryer on page 5-50 . The following instructions are based on inspection of the noise control system at regular intervals as indicated in the Noise Control System Maintenance Log on page 5-123 . Check condition. Is the insulator secure? How you do this will depend on the method of attaching the noise insulators on the engine and around the oil pan (bolts, snap fasteners, or straps). Tighten loose fasteners and repair or replace any worn or damaged fasteners.
Check the induction tubing, elbow connections, clamps, brackets, and fasteners for deterioration, cracks, and security. If, during periodic inspection and maintenance of other systems and components, it is found that parts of the noise control system require attention, we recommend that those parts be inspected at more frequent intervals to assure adequate maintenance and performance. If you find an air leak anywhere between the air cleaner and the engine, repair that leak immediately. Check insulators around fasteners and stress points, especially where they may be affected by engine vibration. Repair any cracked or damaged mounting points.
Use suitable reinforcing plates to ensure that the insulators will remain in position. 5 CAUTION Air leaks cause excessive noise and may result in serious damage to the engine. If you do not repair them the engine damage will not be covered by your warranty. Repair all air leaks as soon as you find them. 5-117