WHAT TO DO IF... Fuse Inspection and Replacement Before replacing a fuse, turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. CAUTION If it is blown, replace it with a fuse of the same rating. All the electrical circuits have fuses to protect them from a short circuit or overload. If something electrical on your chassis stops working, the first thing you should check for is a blown fuse. If a fuse of the same rating is not available, a fuse of a lower rating may be temporarily substituted. You can also use a fuse from a circuit you can do temporarily without (for example an accessory circuit or radio).
2 CAUTION Never patch fuses with tin foil or wire. This may cause serious damage elsewhere in the electrical circuit, and it may cause a fire. 1. Turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. CAUTION When replacing a failed circuit breaker, always use an approved circuit breaker with a current rating equal to or less than the circuit breaker being replaced. Only use the approved Type II modified reset circuit breakers. NEVER use a Type I (automatic reset) or Type III (manual reset) circuit breaker. A fuse with a current rating equal to or less than the circuit breaker being replaced can also be used. CAUTION 2.
Determine from the chart on the fuse panel which fuse controls that component. If a circuit keeps blowing fuses, have the electrical system inspected for a short circuit or overload by an authorized dealer as soon as possible. Failure to do so could cause serious damage to the electrical system and/or vehicle. 3. Remove that fuse and see if it is blown. 1 Blown 2-7