Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Coolant Level, Add Coolant WARNING is of If SYSTEM (PAGE 4-25)". 3 - 112 Checks Before Always check th e items in this section bef ore starting the engi ne each Do not open the radiator cap unless necessar y. When checking the coolant, a lways wait for the engin e to cool down and check the sub tank. Immediately afte r the engine is stopped, the coolant is at a high tem perature and the radiator is und er high internal pressure. If the cap is rem oved to check the coolant le vel in this condition, t here is a hazard of burns. Wait for the temperature to go down, then turn the cap slowly to release the pressure and remove it carefully . 1.

Open the do or at the rear left of the ma chine, and check if coolant in su b-tank (1) (shown in the diagram on the right between the FULL and LOW marks. If the coolant level is l add coolant t o the FULL level through t he filler port of sub-t (1). coolant, tighten the cap securely. nk (1) is empty, there is probably leakage r inspecting, repair any problem immediately 2. After adding coolant, tighten the cap s 3. If the sub-ta nk (1) is empty, there i r inspecting, repair any p coolant. Afte roblem immediately there is no p roblem, check the coolan t level in the radiato the coolant le vel is low, add coolant to the radiator, then fill sub-tank (1). 4.

If the inside of sub-tank (1) is dirty and the water level can be seen, use the procedure in "CLEAN INSIDE OF COOLI Drain Water And Sediment from Fuel Tank machine. 1. 2. 3. 4. 5. 1. Open the co ver on the right side of the 2. Set a contain er under drain hose (1) to catch the drained f Turn drain va lve (2) to the OPEN (O) p osition and drain all sediment an the fuel. d water accumulated at the bottom together 4. When clean f uel comes out, turn drain valve (2) to the CLO (S) position. or. 5. Close the do