. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS REMARK 3 - 128 1. When r emoving cover (1), inse rt a flat-headed screwdriver into the hol e of cover (2), push the tooth on the inside , and remove the cov 2. Remov e 2 bolts (3). 3. Remov e cover (1 4. Loosen and adjust mounting angle ( A) of the c amer a so tha t the center line of mounting bolt (4) is al igned wit h fourth-from-bottom scal Part of the machine i s shown on t he monitor screen. 5. After a djusting, ti ghten bolt (4) Tighten ing torqu e: 3-5 Nm (0. 3-0.5 kgm, 2.2-3.6 lbft)