. OPERATION MACHINE OPERATIONS AND CONTROLS Breaking-in the New Machine operating the Engine Warm Up of the 3 to monitor 3 - 136 NOTICE Your Komatsu machine has b een thoroughly adjusted and tested before shipment from the factory. machine under full load befor e breaking the machine in can advers ely affect th e performance and shor Be sure to break in the machi ne for the initial 100 hours (as indicat ed on the service meter). Make sure that you fully un derstand the content of this manua l, and pay careful attention to the following points when breaking in the machine. Run the engine at idle f or 15 seconds after starting it.
Du ring this time, do not operate the control levers or fuel control dial. utes after starting it up. avy loads or at high speeds. Idle the engine for 5 min Avoid operation with he Immediately after startin g the engine, avoid sudden starts, sudden acceleration, unnecess ary sudden stops, and sudden changes in dire ction. NOTICE Do not accelerate the engin e suddenly until the warm-up operati been completed. Do not run the engine at low idling or high idling under no load fo than 20 minutes. This will and will also have an adv have an adverse effect on the enviro erse effect on the internal structure engine.
If it is necessary t o run the engine at idling for more t minutes, apply a load from time to time or run at a mid-range sp After the engine starts, do n ot start operating the machine im mediately. First, carry out the fol lowing operations and checks. 1. This machine is equip below 30 °C after the e automatic warm-up op speed. If the engine water tem 10 minutes, the autom speed. ped with an automatic engine warm-up system, so if the engine water temperature is ngine is started, the engine war m-up operation starts automatica lly.
When the engine eration starts, the engine speed is maintained at a speed higher tha n the normal low idling perature goes above 30 °C or if th e warm-up operation has been co ntinued for more than atic warm-up operation is cancelle d and the engine speed drops t o the normal low idling 2. Check that engine co olant temperature monitor (1) dis e. rature, use the procedure in Ste the correct temperatur If it displays low tempe carry out additional w displays the correct te (A) Display when temp (B) Display when temp arm up of the engine until the m mperature. erature is correct: Monitor backg (C) is blue erature is low: Monitor backgrou is white