. OPERATION TRANSPORTATION LIFTING MACHINE WARNING NOTICE the right using the boom cylinder. 3 - 186 The operator ca rrying out the lifting oper ation using a c rane mu st be a properly qualified crane o Never raise the machine with any worker Always make su re that the wire rope is of ample strengt h for the weight When lifting, ke ep the machine horizontal When carrying o ut lifting operations, set th e lock lever to the LOC K position to prevent the machine from moving unexpectedly. Never enter the area under or around a ra ised machine.
Never try to lift the machine in any posture o ther than the p osture g iven in the procedure below or u sing lifting equipment other than in the proced ure below. hat the machine may lose its balance. There is a hazard t hat the machine may lose This method of lifti ng applies to the standar d specification machine The method of lifti ng differs according to the attachments and options For details of the p rocedure for machines th at are not the standard specification, please consult yo ur Komatsu distributo For weight, see " When lifting the machine, carry out the operation on flat ground as 1.
Start the eng ine, then the swing the upper struct ure so t hat the work equipment will b e on the side of spr ocket (1). 2. Extend the b ipment to the ground a s shown in th e diagram 3. Set the lock lever securely to the L OCK position 4. Stop the eng ine, check that there is nothing aro und the operator's compartment, then get off the machin Close the ca b door and front glass securely.