. MAINTENANCE MAINTENANCE INFORMATION MAINTENANCE INFORMATION Service Meter Reading Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. Komatsu Genuine Lubricants For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature.
4 - 2 Do not perform any i nspection and maintenance ope ration that is not fo Komatsu Genuine Re placement Parts Use Komatsu genui ne parts specified in the Parts Bo ok as replacemen Windshield Washer F luid Use automobile wind ow washer fluid, and be careful not to let any dirt g Fresh and Clean Lub ricants Use clean oil and gr ease. Also, keep the containers o f the oil and greas e clean. Keep foreign materials a way from oil and grease. Check Drained Oil an d Used Filter After oil is changed o r filters are replaced, check the ol d oil and filters for m etal particles and for eign materia ls. If l arge quantity of metal pa suitable action.
rticles or foreign materials are found, always report to the person in charge, and carry out harge, carry Fuel Strainer If your machine is eq uipped with a fuel strainer, do no t remove it while f Welding Instructions Cut off power. Wa it for approx. one minute after tu rning off the engin e starting switch key , and then di sconnect the negative (-) te rminal of the battery. than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. Do not apply more Connect groundin g cable within 1 m (3.3 instruments, conn ectors, etc., the instruments may malfunction.
If a seal or bearing happens to come between the p art being welded a nd grounding point, change the g rounding point to avoid suc h parts. ea around the work equipment pins or the hydraulic cylinders as the grounding point. Do not use the ar ea around the work equipment pi ns or the hydraulic cylinders as the gro unding point Do not Drop Things I nside Machine When opening ins pection windows or the oil filler p ort of the tank to carry out inspection, be careful n ot to drop nuts, bolts, or tool If such things are lead to failure. If y s inside the machine.
dropped inside the machine, it m ay cause damage and/or malfunction of the machine , an d will ou drop anything inside the mac hine, always remo ve it immediately. r inspection. Do not put unnec essary things in your pockets. C arry only things wh ich are necessary fo r inspection.