Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE Cleaning Outer Element NOTICE Before and after cleaning the element, do not leave or keep it in direct sunlight. lights up soon after 4 - 20 1. Open the door on the left sid e of the machine, remove 3 hooks (2), then remove cover (3). NOTICE Never remove the inner element (6). It will allow dirt to enter and cause failure of the engine. r tool. Do not use a screwdriver or othe 2. Hold the outer element (5), rock it lightly up and down and to the left and right, and rotate pull it out. the element to the left and right to 3. When the outer element (5) has been removed, check that the inner element has not com angle. If is is at an angle, straight.

e out of position and is not at an insert your hand and push it in 4. After removing the outer el ement (5), cover the inner element (6) with a clean cloth or t entering. ape to prevent dirt or dust from 5. Wipe off or brush off the dirt stuck to cover (3) and the inside of the air cleaner body (7). 6. Remove any dirt or dust that is accumulated to evacuator valve (4) installed to cover (3). OTICE When cleaning the element, do not 7.

Direct dry compressed air (l PSI)) to the outer element direct it from outside along 1) Replace the outer ele times repeatedly or use inner element at the sa 2) Replace both inner an installing the cleaned o uter element even though it has not been cleaned 6 times.