Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE at an it in 4 - 23 Replacing Ele 1. Open the d oor on the lef t sid e of the mach ine, remove 3 (2), then re move cover ( 2. Hold the ou ter element (5), rock it lightly up and down a the left and right, and rotate the element t o the left and ri pull it out. Do not rem ove inner elemen t (6) when d 3. When the o uter element (5) has been rem oved, check th inner elem ome out of posi tion and is not angle. If is straight. 4. Wipe off or brush off the dirt s tuck to cove r (3) and the ins the air clea ner body (7). 5.

Remove an y dirt or dust that i s accumulat ed to evacuator (4) installed to cover (3) NOTICE The inner elem ent must not be cl eaned and us ed again. When r eplacing the outer element, replace the inner element at the same time. If the inner ele ment is not installed properly and the outer element and cov er are installed, there is dang er that the outer element will be damag ed. The seal porti on on imitation part s lacks precisi on, and allows th e entry of dust, which leads to dama ge of the engine. Do not use such imita tion parts. 6. Remove in ner element ( 6), t hen quickly i nstall the new i Insert the in ner element securely so that it does not mov 7.

Push the n ew outer element (5) in straig ht with your han d when installing it to the air cle If the eleme nt is held an d rocked lightly up and down and to the l eft and right while pushin g it in, the element can be inserted