Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE from 4 - 43 NOTICE If the air is not bled from the swing motor, the motor bea rings ma y be d When replacing the trave l motor safety valve, p lease con tact your Koma tsu distributor to h ave it replaced and to have the air bled. 5. Bleeding air from tra (Bleed the air only when the oil inside the travel motor case ha 1) Run the engine at low idling, loosen air bleeder (1), and check that oil flows out.

(Bleed the air only w hen the oil inside th e travel m otor case ha 1) Run the engine check that oil flo 2) Run the engine a t low idle and swin g the wor 90° to bring it to t he side of the track 3) Jack up the mac hine until the track slightly the ground.Rotat e the track under n o load for Repeat this proc edure on both the le ft and rig ht sides, rotate the track e qually both forward and in re verse. 6. Bleeding air from att achment (when installed) I f a breaker or other a ttachment has bee n installed , run th e engi ne at low idle and operate the attach ment peda repeatedly (approx. 1 0 times) until the ai r has be en bled from t he attachment cir cuit.

NOTICE If the method of bleeding the air from the attachment its elf is specified by the manufactur er, bleed the air acc ording to the specified procedure. After completing the air b leeding operation, st op the eng ine, and leave t he machine for 5 m inutes before startin g operations. This will remove the air b ubbles in the oil insid e the hydr aulic cylinders. pilled. he oil level is low, add oil. Chec k that there is no le akage of oil and wipe off any oil that has been s After completing the air b leeding operation, in spect the o il level, and if t he oil level is low, a