Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 45 7. Loosen ring nut (6) to remo ve casing (7). 8. Remove screen (8) from th e water separator table, pulling the screen out downward. fuel. 9. Wash screen (8) with clean At that time, also check it fo r damage and if any, replace it with a new one. (7) for damage, a crack or so bad 10. Wash the interior of casing a contamination as to make it impossible to identify the location of float (9), and if any of the m is found, replace the casing with a new one. ter separator table. new one. 4). 11. Install screen (8) on the wa 12. Replace O-ring (10) with a 13. Screw in water drain plug ( Tightening torque:

1.5 - 2.5 Nm (0.15 - 0.25 kgm, 1.1 - 1.8 lbft) 14. Put float (9) in casing (7) th e way it does not tilt, and then pour clean fuel in the casing cal mly. 15. Install casing (7) on the wa ter separator table and tighten ring nut (6). Tightening torque: 16 - 20 Nm (1.6 - 2.0 kgm, 11.6 - 14.5 lbft) 16. Connect drain hose (2). has been loosened to drain fuel, 17. In case air intake plug (5) tighten it now. Tightening torque: 8.0 - 12. 0 Nm (0.8 - 1.2 kgm, 5.8 - 8.7 lbft) 18. Turn fuel valve (3) to the "O PEN" position (O). 19. Close the inspection cover. 20. When the whole work is fin ished, bleed air from the water separator the same way as when replacing t he fuel filter cartridge.

ure, see "REPLACE FUEL PRE-FILTER CARTRIDGE (PAGE 4-56)", "REPLACE RIDGE (PAGE 4-68)". For the air bleeding proced FUEL MAIN FILTER CART