. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (only machines equipped with air conditioner) WARNING 1. Open engine hood (1). 4 - 59 If compressed air, high-pressure wa ter, or steam hits your body directly or dirt is sent flying by the co mpressed air, high-pressure water, or steam, there is danger of p ersonal injury. Always wear protective glasses, dust mask, and other protective equipment. NOTICE When using compressed air for clea ning, blow it keeping some distance to avoid damaging the fins. D amage on the fins can cause water leakage and overheating.
In a dusty job site, check the fins ever y day, regardless of the maint enance interval. 2. Loosen nut (3) and pull up n et (2). n it. 3. After pulling up net (2), clea (Install it again in Step 7.) 4. Check the front and rear sur faces of oil cooler fins (4), radiator fins (5), aftercooler fins (6), Air conditioner condenser fins ( 7), and fuel cooler fins (8). If the re is any mud, dirt, or leaves stuck to the fins, blow the dirt off w Steam or water may be u However, when carrying ith compressed air. sed instead of compressed air.
out powerful steam cleaning wash) of the heat exchange oler, aftercooler, fuel cooler, air intain sufficient distance from the (high-pressure machine equipment (radiator, oil co conditioner condenser), ma air the machine when carrying out the operation. If steam cleaning sh) is carried out at close range, ternal fins of the heat exchange (high-pressure machine wa there is danger that the in equipment may be deformed , and this will cause early clogging and breakage. 5. Check the rubber hose. Re place with a new one if the hos e is found to have cracks or to b e hardened by aging. In addition, check the hose clamps for l ooseness.