Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING temperature immediately after the engine is stopped, and may cause burns. Wait for the 4 - 65 EVERY 1000 HOURS MAIN Carry out the periodic maintenan ce work of every 100, 250 and 500 hours of operation at the The parts and oil are at high tem temperature to go down before sta When removing the oil filler cap, t NOTICE f the machine is equipped with a hy draulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. For details, see "MAIN maintenance. TENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out 1.

Set the work equipment on the hard and flat ground in the maintenanceposture as show n in the figure, then lower it to the ground and stop the engine. 2. Remove the cap from oil fill pressure. Loosen 6 bolts, then remove cover may fly out under the er (F), and release the internal cover (1). When doing this, the force of spring (2), so hold the he bolts. lve (3) and strainer (4), take out 3. cover down when removing t 4. After removing spring (2), va element (5). Inspect the bottom of the fil any. Take good care the hydraulic tank. cover down when removing t After removing spring (2), va element (5).

Inspect the bottom of the fil ter case for dirt, and remove it, if n not to let fall the dirt into the ushing oil. 5. Clean the removed parts in fl 6. Install the new element in the place where old element (5) was 7. installed. Set valve (3), strainer (4) and spring (2) on top of the element. 8. Set cover (1) in position, pus h it down by hand, and install the cover with the mounting bolts . install the cover. ngine according to "STARTING 9. Screw in the oil filler cap and 10. To bleed the air, start the e ENGINE (PAGE 3-132)" and minutes. Stop the engine. run the engine at low idle for 10 11.