. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING cause burns. Wait for the 4 - 83 EVERY 5000 HOURS MAI NTENANCE Carry out the periodic maintena nce work of every 100, 250, 500 and 1000 hours of opera The parts and oil are at high te mperature immediately after the engine is stopped, and may tarting the work. turn it slowly to release the internal pressure, then remove it. temperature to go down before s When removing the oil filler cap, NOTICE If the machine is equipped with a h ydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket If operations. For details, see "MA maintenance.
INTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out Refill, capacity: 121 liters (31. Prepare a handle (for the soc 1. Swing so that the drain plug is in the middle between the 2. Retract the arm and bucket c put the teeth in contact with 3. Set the lock lever to the LO 4. Remove the cap of oil filler port (F) at the top of the hydraulic er the drain plug located on the h oil that is drained. Remove drain eck an O-ring installed to Plug (P), age, replace it with new one. After plug (P). torque is 68.6 ± 9.81 Nm (7 ± 1 n yourself when you remove drain tank. Set a container direct und 5. machine's underside to catc plug (P) and drain the oil.
Ch and if it has a scratch or dam draining the oil, tighten drain The specified tightening kgm, 50.6 ± 7.2 lbft) Take care not to get oil o plug (P). machine's underside to catc plug (P) and drain the oil. Ch and if it has a scratch or dam draining the oil, tighten drain The specified tightening 6. Add the specified amount of new and clean oil through oil filler port (F). Check that the oil level is between H and L on the sight gauge. oil, see "RECOMMENDED FUEL, COOLANT, AND LUBRICANT (PAGE 4-9)". For details of the suitable For details of the method 3-118)". For details of the method of checking the oil level, see "Check Oil Level in Hydrau lic Tank, Add Oil (PAGE ulic circuit. 7.
Bleed the air from the hydra For details of the method of b leeding the air from the hydraulic circuit, see "BLEEDING AIR FROM HYDRAULIC SYSTEM (PAGE 4-42)".