Komatsu — HYDRAULIC CIRCUIT

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT Replace Additional Breaker Filter Element WARNING personal injury. Always wear safety glasses, dust mask, and other protective equipment. NOTICE 6 - 11 I topped high emperature a efore startin f compressed nd may cause burns g the operation. air is used, there . Wait for the temperature to go down is danger of dirt flying and causing oil are For details of the replacement interva l for the element , see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" Prepare a co ntainer to catch t he oil. 1. Lower the work equipment to the ground a nd stop t he engine. 2.

Turn the sta rting switch to the ON position ( B), then set the lock lever to the FREE position (F ). 3. After carryi ng out Step 2, ope rate each work equipmen t control lever and a ttachment control pedal fully to the fron t, rear, left, and right 2 or 3 times w ithin 1 5 seconds to r elease t he internal pressure in the hydraulic circ uit.