11 10 9 8 7 6 5 4 3 2 1 Long-term Before storing your ATV for several months: 1. Follow all the instructions in the “Cleaning” G To prevent corrosion, avoid damp cellars, stables (because of the presence of ammo- nia) and areas where strong chemicals are stored. G Storing the ATV in a poorly ventilated room or covering it with a tarp while it is still wet, will allow water and humidity to seep in and cause rust. CAUTION: ECB00720 Short-term Always store your ATV in a cool, dry place and, if necessary, protect it against dust with a porous cover. EBU25951 Storage increasing the chance of an accident. Test the brakes after washing.
Apply the brakes several times at slow speeds to let friction dry out the linings. 9-2 5. Perform the following steps to protect the cyl- inders, piston rings, etc. from corrosion. a. Remove the spark plug caps and spark plugs. b. Pour a teaspoonful of engine oil into each spark plug bore. c. Install the spark plug caps onto the spark plugs, and then place the spark plugs on the cylinder head so that the electrodes are grounded. (This will limit sparking dur- ing the next step.) d. Turn the engine over several times with the starter. (This will coat the cylinder walls Specified amount:
7.5 ml of stabilizer to each liter of fuel (or 1 oz of stabilizer to each gallon of fuel) section of this chapter. 2. Turn the fuel cock lever to “OFF”. 3. Drain the carburetor float chamber by loosen- ing the drain bolt; this will prevent fuel deposits from building up. Pour the drained fuel into the fuel tank. 4. Fill up the fuel tank and add fuel stabilizer (if available) to prevent the fuel from deteriorat- ing.