11 10 9 8 7 6 5 4 3 2 1 Tightening torque: Transmission oil drain bolt: 20 Nm (2.0 m·kgf, 14 ft·lbf) 5. Install the drain bolt, and then tighten it to the specified torque. 1. Transmission oil drain bolt 2. Start the engine, warm it up for several min- utes, and then turn it off. 3. Place an oil pan under the transmission to col- lect the used oil. 4. Remove the oil filler cap and the drain bolt to drain the oil from the transmission. 1 8-11 7. Start the engine, and then let it idle for several minutes while checking the transmission for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. 8.
Turn the engine off, and then check the oil lev- el and correct it if necessary. G In order to prevent clutch slippage (since the transmission oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel specification of “CD” or oils of a higher quality than specified. In ad- dition, do not use oils labeled “ENERGY CONSERVING II” or higher. G Make sure that no foreign material enters the crankcase. CAUTION: ECB00430 Recommended transmission oil: See page 10-1. Oil quantity: 1.5 L (1.59 US qt) (1.32 Imp.qt) 6. Add the specified amount of the recommend- ed transmission oil, and then install and tight- en the oil filler cap.