1. POWER CIRCUIT The negative terminal of battery is grounded to the machine chassis directly. When the start switch is in the OFF position, the current flows from the positive battery terminal as shown below.
OPERATING FLOW OPERATING FLOW Battery Battery relay [CR-1] Circuit breaker [CN-60] Master switch [CS-74] Fuse box [No.1] I/conn [CN-2 (8)] ECM [CN-94 (3, 4)] Fuse box [No.2] Power relay [CR-35 (30)] ECM power relay [CR-46 (3)] Fuse box [No.3] MCU [CN-51 (1)] Fuse box [No.4] I/conn [CN-5 (9)] l/conn [CN-10 (3)] Room lamp [CL-1 (2)] Door switch [CS-1] Radio & USB player [CN-27A (8)] Fuse box [No.5] Master switch [CS-74B] l/conn [CN-5 (36)] Start switch [CS-2A(1)] RMS [CN-125A (1)] GPS connection [CN-125 (1)] Fuse box [No.6] l/conn [CN-11 (5)] AC & Heater controller box (A) Blower relay (4) Fuse box [No.7] I/conn [CN - 5 (18)] I/conn [CN -17 (5)] Wiper motor controller [CN-141 (7)] Wiper motor [CN-21 (4)] Fuse box [No.8] I/conn [CN - 5 (11)] Cluster [CN -56A (1)] Hour meter [CN-48 (1)] I/conn :
Intermediate connector CHECK POINT CHECK POINT 侍 # GND : Ground 4-6 1) 2) OPE Batt 侍I/ CHE Engine Start switch Check point Voltage STOP OFF 刮 - GND (battery 1EA) 刯 - GND (battery 2EA) 到 - GND (battery relay) 刱 - GND (circuit breaker) 10~12.5V 20~25V 20~25V 20~25V