Komatsu — FELLING TREES, REMOVING STUMPS

OPERATION 2 WORK POSSIBLE USING MOUNTED EQUIPMENT In addition to the following, it is possible to further increase the range of applications by using various attachments. 2 DOZING A dozer digs and transports dirt in a forward direction. Slope excavation can always be most effectively carried out by proceeding from the top downward. When dozing toward one side only, operate with angled blade. 2 SMOOTHING Remark Avoid smoothing on rocky or stony ground. It can damage the blade. Uneven ground surfaces remaining after digging can be leveled off by fine operation of blade. The basic method is to operate the machine at low speeds with the blade fully loaded with soil and sand.

A flat fin- ished surface is also possible by slowly backing the machine with the blade floating so it is dragged across the surface. However, avoid this on rocky or stony ground, as it may damage the blade. 2 CUTTING INTO HARD/FROZEN GROUND OR DITCHING Remark Do not perform severe operations such as uprooting by an- gling or tilting the blade. For digging and ditch excavation of hard or frozen ground, tilt the blade. Even hard ground can be dug effectively by a tilted or angled blade. 2 FELLING TREES, REMOVING STUMPS Remark Do not up root trees or stumps or fell trees by angling or tilting the blade.

For trees with a diameter of 100 to 300 mm (3.9 to 11.8 in), raise the blade high and push two or three times to fell the tree. Next, travel in re- verse, and dig the corner of the blade into the ground to cut and dig up the roots. When doing this, never hit the tree at high speed or apply shock to fell the tree. 2-70 D87E-2 D87P-2