OPERATION 2. Disconnect the negative cable (1) from rear battery. Disconnect the positive cable (2) from the front battery. Disconnect and re- move cross over to cable (3) from each battery. Remove front long bolts (4) then single rear bolt and retainer plate (5). Remove batteries from compartment. To install batteries, reverse the removal procedure installing batter- ies with positive terminals facing forward. Battery terminal nut ................................ 30 N•m (22 lbf ft) Long bolts (4).............................................. 9 N•m (7 lbf ft) 2 When Connecting and Disconnecting Booster Cable When starting the engine with a booster cable, always wear safety glasses.
Be careful not to let the normal machine and problem machine con- tact each other. This prevents sparks from generating near the bat- tery which could ignite the hydrogen gas given off by the batteries. If hydrogen gas explodes. It could cause serious injury. Make sure that there is no mistake in the booster cable connections. The final connection is to the engine block of the problem machine, but sparks will be generated when this is done, so connect to a place as far as possible from the batteries. Use care when removing the cables from the machine that has been started. Do not allow the cable ends to contact each other or the ma- chine, to avoid hydrogen explosion.
Remark The size of the booster cable and clip should be suitable for the battery size. The battery of the normal machine must be the same capacity as that of the engine to be started. Check the cables and clips for damage or corrosion. Make sure that the cables and clips are firmly connected. 2 Connecting With Starting/Charging Receptacle (Optional attachment) 1. Open left engine access door. Remove plug from receptacle. 2. With charging receptacle attach to a host machine, insert at problem machine. Start host machine and allow a few minutes precharge time. D87E-2 D87P-2 2-91