OPERATION 2 METHODS OF TOWING MACHINE When using a chain or cable, be sure it is strong enough for the ex- pected load and it is properly secured to the drawbar pins, ripper toolbeam or tow hook. When pulling with a chain or cable, take up the slack slowly to avoid jerking. A chain or cable which fails under load can whip and cause serious injury. Stand clear. Do not pull or tow unless the operator’s compartment is guarded against or out of reach of a whipping chain or cable. Attach only to the machine tow hook, ripper toolbeam or drawbar. Failure to follow these instructions could cause serious in- jury.
Remark If the steering drive, final drive or tracks are damaged, do not tow the machine. The machine must be transported on a car- rier to avoid further damage. To avoid the possibility of power train damage, limit the towing to a dis- tance of 0.8 km (0.5 mile) at speeds less than 1.6 km/h (1 mph). The brakes on this machine are automatically spring applied when the en- gine is stopped. The brakes can only be released hydraulically. A towing port for applying external pressure to release each side brake is located in the left side box below the drive train filter. If the machine can be towed and the engine and steering hydraulic system can be operated, proceed as follows: 1.
Position the safety lock lever in the up position. Start the engine. Use a towing cable of sufficient strength. Keep the engine running at half throttle and the safety lock locked in the up position during the tow. If the machine can be towed but the engine and/or steering hydraulic system is/are inoperable, proceed as follows: 2. Open the left side door. Modify a grease gun by installing a female quick disconnect fitting and hose of sufficient length to the right brake port as marked. This will allow operation of the grease gun from the operator’s seat for releasing the spring applied brakes. 3. Pump sufficient grease into the fitting to release the brakes.
The amount of grease required depends on the amount of pressure dissi- pation in the system. 4. Use a towing cable of sufficient strength. During the tow, it may be necessary to pump more grease into the brake release fittings to re- place the loss of pressure. Stop towing the machine before reapplying grease to the fittings. 5. Depressing the brake pedal will relieve pressure and apply the brakes. When towing is completed, remove the grease gun and close the left side door. 2-96 D87E-2 D87P-2