Komatsu — RELATING TO ELECTRICAL SYSTEM

3 COOLANT MAINTENANCE River water contains large amounts of calcium and other impurities, so if it is used, scale will stick to the engine and radi- ator, and this will cause defective heat exchange and overheating. Do not use water that is not suitable for drinking. When using antifreeze, always observe the precautions given in this Operation & Maintenance Manual. These machines are supplied with antifreeze in the coolant when the machine is shipped. This antifreeze is effective in preventing corrosion of the cooling system. Therefore, it can be used as it is even in hot areas. Antifreeze is volatile, so be extremely careful not to expose it to flame or fire.

The proportion of antifreeze to water differs according to the ambient temperature. For details of the mixing proportions, see “COOLING SYSTEM” on page 3-10 If the engine overheats, wait for the engine to cool before adding coolant. If the coolant level is low, it will cause overheat- ing and will also cause problems with corrosion from the air in the coolant. 3 GREASE Grease is used to prevent twisting and noise at the joints. The nipples not included in the maintenance section are nipples for overhaul, so they do not need grease. If any part becomes stiff after being used for a long time, add grease. Always wipe off all of the old grease that is pushed out when greasing.

Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. 3 STORING OIL AND FUEL Keep indoors to prevent any water, dirt, or other impurities from getting in. When keeping drum cans for a long period, put the drum on its side so that the filler port of the drum can is at the side, to prevent moisture from being sucked in. If drum cans have to be stored outside, cover them with a waterproof sheet or take other measures to protect them. To pre- vent any change in quality during long-term storage, be sure to use in the order of first in - first out, use the oldest oil or fuel first.

3 FILTERS Filters are extremely important safety parts. They prevent impurities in the fuel and air circuits from entering important equipment and causing problems. Replace all filters periodically. For details, see the procedures in this Operation & Main- tenance Manual. However, when working in severe conditions, it is necessary to consider replacing the filters at shorter intervals according to the oil and fuel (sulfur content) being used. Never try to clean the filters (cartridge type) and use them again. Always replace with new filters. When replacing oil fil- ters, check if any metal particles are stuck to the old filter.

If any metal particles are found, please contact your distributor. Do not open packs of spare filters until just before they are to be used. Always use Komatsu genuine filters. 3 RELATING TO ELECTRICAL SYSTEM If the wiring gets wet or the insulation is damaged, the electric system leaks and this could result in hazardous malfunction of the machine. Services relating to the electric system are (1) check of fan belt tension, (2) check of damage or wear in the fan belt and (3) check of battery fluid level. Never remove or disassemble any electric components installed in the machine. Never install any electric components other than these specified by Komatsu.

Be careful to keep the electric system free of water when washing the machine or when it rains. When working on the seashore, carefully clean the electric system to prevent corrosion. Never connect any optional power source to the fuse, starting switch, battery relay, etc. D87E-2 D87P-2 3-5