MAINTENANCE 3 STANDARD TIGHTENING TORQUES 3 INTRODUCTION OF NECESSARY TOOLS The following tools are needed when carrying out maintenance. If any of the above tools are broken, please order them from your distributor. When not using the tools, always put them in the appropriate tool box. D87E-2 D87P-2 3-13 No. Name of tool Part No. Description 1. Wrench Set 09000-30006 Width across flats - S1xS2 Open end wrench - 8x10 mm Open end wrench - 12x14 mm Open end wrench - 13x17 mm Open end wrench - 19x22 mm Open end wrench - 24x27 mm Open end wrench - 30x33 mm 2.
Tool Kit 276 820 R91 Open end wrench - 7/16x1/2 Open end wrench - 9/16x5/8 Open end wrench - 5/8x11/16 Open end wrench - 3/4x13/16 Open end wrench - 15/16x1 Screwdriver - 1/4 shank Screwdriver - 3/8 shank Ball peen hammer Pry bar - 9/16x16 Adjustable wrench Center punch - 5/16x10 Chisel - 7/8x10 Pin punch - 3/16x10 Vise grip wrench Slip joint plier Diagonal (side) cutter Tool box 3. Filter Wrench DR02-535 Removal of filter cartridge 4. Grease Pump 999 677 R91 For lubrication of machine 5. Grease Cartridge For type, see “USE OF FUEL, COOLANT AND LUBRICANTS” on page 3-7