MAINTENANCE 3. With the engine stopped, open the left engine side door. 4. Position a catch container under the fuel filter cartridges (1). Loosen the plug (2) at the bottom of cartridge and drain fuel. 5. Before loosening the filter, clean the filter head to prevent dirt or foreign material from entering the system. Remove the fuel filter from the filter header by turning counterclockwise. A filter wrench can be used if unable to turn the filter by hand. Discard the fuel fil- ter in a suitable container. 6. Thoroughly clean the fuel filter header with kerosene or diesel fuel to prevent dirt or foreign material from falling into the new filter.
Keep the new filter in the original package until ready for installa- tion. 7. Fill fuel filters with clean fuel. 8. Apply a light coating of clean engine oil or chassis grease to the seal surface on the new filter. 9. Install, but do not spin, the new filter, turning it until the seal just contacts the filter head. Make aligning marks on the filter and the filter header and tighten the filter an additional 1/2 to 3/4 turn. Open the fuel line shutoff valve. Remark Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter. Mechanical over tightening may distort the filter header threads or dam- age the element seal. 3-42 D87E-2 D87P-2