Komatsu — PIVOT SHAFT HOUSING OIL LEVEL

MAINTENANCE 7. Fill fuel filters with clean fuel. 8. Apply a light coating of clean engine oil or chassis grease to the seal surface on the new filter. 9. Install, but do not spin, the new filter, turning it until the seal just contacts the filter head. Make aligning marks on the filter and the filter header and tighten the filter an additional 1/2 to 3/4 turn. Open the fuel line shutoff valve. Remark Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter. Mechanical over tightening may distort the filter header threads or dam- age the element seal. 10. After replacing the fuel filter cartridge, loosen the air bleed plug (3).

Loosen the knob of fuel feed pump (4), then operate it up and down until no more bubbles come out with the fuel from air bleed plug. Tighten air bleed plug (3), then push in the knob of feed pump and tighten it. Open the fuel shut off valve at the rear of the ma- chine. 11. After replacing the filter cartridge, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage of fuel, check the tightening of the filter cartridge. When- ever there is leakage of fuel, follow steps 1 through 5 to remove the filter cartridge, then check the packing surface for damage or for- eign material.

If any damage or foreign material is found in the packing, replace the packing with a new part, then repeat Steps 5 through 12 to install the filter cartridge. 3 PIVOT SHAFT HOUSING OIL LEVEL Remove the plug (one at each side), check the oil level. The proper level is at the bottom of the plug opening. If the lubricant is low, fill to the bottom of the plug opening. Reinstall and tighten the plug. For details of the fluid to use, see “USE OF FUEL, COOLANT AND LUBRICANTS” on page 3-7. 3-50 D87E-2 D87P-2