Komatsu — REPLACE CORROSION RESISTOR CARTRIDGE

MAINTENANCE 4. Clean the filter holder, coat the thread and the seal surface of the new cartridge thinly with engine oil, then install the cartridge. 5. Install the filter by threading (do not spin) it onto the filter base un- til the seal contacts the base, turn the filter by hand an additional 2/ 3 turn. Open each shut off valve lever. Remark Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter. Mechanical over tightening may distort the filter header threads or dam- age the element seal. 6. After replacing the cartridge, start the engine and check that there is no leakage of coolant from the filter seal surface.

If any coolant leakage is found, check the tightening of the cartridge. 3-60 D87E-2 D87P-2