Komatsu — WEAR OF UNDERCARRIAGE COMPONENTS

MAINTENANCE Steering Lever Pivot (5) 2 FITTINGS Apply grease until clean lubricant is visible. Always use a clean lubrica- tor and wipe dirt from fittings before fresh grease is applied. If grease fails to go through the fitting, determine the cause and correct it. After greasing, wipe off any old grease that was purged. Steering Valve Lever (6) 1 FITTING Apply grease until clean lubricant is visible. Always use a clean lubrica- tor and wipe dirt from fittings before fresh grease is applied. If grease fails to go through the fitting, determine the cause and correct it. After greasing, wipe off any old grease that was purged. 3 WEAR OF UNDERCARRIAGE COMPONENTS 3 Track Frame Guide 1.

To avoid excessive wear of undercarriage components and track frame suspension points, the track frame guide must be checked pe- riodically. 2. Adjust as follows: A. Measure clearances A and B . If the total is 6.5 mm (0.256 in) or more, adjust by removing shims (1) from between the spacer blocks (2) and wear plates (3 and 4). Remove enough shims to reduce the total clearance ( A + B ) to 0.8 mm (0.031 in). Keep the removed shims for future use. B. If removal of all the shims will not provide a total clearance of less than 6.5 mm (0.256 in), replace the wear plates and guide plate (5), as required. Reinstall the shims and repeat the check. Lubricate track frame guides.

3 Equalizer Bar Periodically check the condition of the wear pads (1) that support the equalizer bar (2) ends in the track frame rebound brackets (3). The dis- tance ( A ) between the equalizer bar and rebound bracket is to be mea- sured periodically also. Perform the measurements when both track frames are on level ground. Add or remove shims (4) to obtain a dis- tance of 4.8 to 6.3 mm (0.189 to 0.248 in) ( A ). For replacement of pads, consult your local distributor. D87E-2 D87P-2 3-75