Komatsu — CHECK WIPER BLADES

MAINTENANCE 3 ELECTRIC INTAKE AIR HEATER Before the start of the cold season (once a year), contact your distributor to have the electrical air intake heater checked or repaired for dirt or dis- connections. When inspecting or replacing the electrical air heater, replace the gas- kets with new ones. 0 GREASE CAB DOOR HINGES 2 FITTINGS per door Apply grease until clean lubricant is visible. Always use a clean lubrica- tor and wipe dirt from fittings before fresh grease is applied. If grease fails to go through the fitting, determine the cause and correct it. After greasing, wipe off any old grease that was purged.

3 CHECK WIPER BLADES Check the condition of the wiper blades and replace as necessary. 3 Door Wipers 1. Fold the wiper blade down. Remove the mounting screw and nut, then the blade. 2. Position a new blade to the wiper arm and secure with the screw and nut. 3 Front and Rear Wipers 1. The blade is hooked to the wiper arm. Unclick the center hinge and push off of arm. Lift the blade out to clear the center hinge and re- move. 2. To install, reverse step 1. D87E-2 D87P-2 3-87