SAFETY 1 PRECAUTIONS DURING OPERATION 1 BEFORE STARTING ENGINE 1 SAFETY AT WORK SITE Before entering the operator's compartment, walk completely around the machine and clear the area of personnel and ob- structions. Before starting the engine, thoroughly check the area for any unusual conditions that could be dangerous. Before starting the engine, examine the terrain and soil conditions of the work site. Determine the best and safest method of operation. Make rough terrain areas as level as possible before operation. If you need to operate on a street, protect pedestrians and cars by designating a per- son for work site traffic duty or by installing barriers around the work site.
If water lines, gas lines, telephone lines, and high voltage electrical lines may be buried under the work site, contact each utility and identify their locations. Be care- ful not to sever or cut any of these lines. Check the depth and flow of water before operating in water or crossing a river. Never be in water which is in excess of the permissible water depth. Water depth, see “PERMISSIBLE WATER DEPTH” on page 2-60. 1 FIRE PREVENTION Thoroughly remove wood chips, leaves, paper and other flammable debris that has accumulated in or around the engine compartment. They could cause a fire. Check fuel, lubrication, and hydraulic systems for leaks. Have any leaks repaired.
Wipe up any excess oil, fuel, or other flammable fluids. Check point, see “CHECKS BEFORE STARTING ENGINE” on page 2-30. Be sure a fire extinguisher is present and working. 1 IN OPERATOR’S COMPARTMENT Do not leave tools, spare parts or personal items lying around in the operator's compartment. They may damage, break or jam the control levers or switches. Always put them in their proper place. Keep the operator’s compartment floor, controls, steps and handrails free of oil, grease, snow, and excess dirt. Check the seat belt, buckle and hardware for damage or wear. Replace any worn or damaged parts.
Never use bleach, dye or solvents on the seat belt because this may weaken the webbing and result in personal injury. Clean the seat belt with warm water and a mild detergent. Always use seat belts when operating your machine. Seat belt, see “SEAT, SEAT BELT AND ARM RESTS” on page 2-20. 1 VENTILATION FOR ENCLOSED AREAS If it is necessary to start the engine within an enclosed area, provide adequate ventilation. Exhaust fumes from the engine can kill. 1 PRECAUTIONS FOR MIRROR AND LIGHTS Remove all dirt from the surface of the mirror and lights to ensure that you can see well.
Adjust the rear view mirror so that you can see clearly from the operator’s seat, and always keep the surface of the mirror clean. If any glass is broken, replace it with a new part. Check that the head lamps and working lamps are installed to match the operating conditions. Check also that they light up properly. 1-12 D87E-2 D87P-2